![]() ![]() Then, remove nuts, washers and wiper arms. Remove black caps on two wiper arm retaining nuts. Not sure if we spelled out removal procedure or not but not too hard to do. See if this rewrite of procedure helps more: Monday morning Monday morning desk chair quarterbacking let me think? Once repaired plug in electrical connector and turn of key and wiper stalk and test before reinstalling in the car. To remove splined shafts from frame you have to remove a small lock ring.ĩ. Pop arms back on ball joint using water pump pliers to squeeze bushing back on ball joint.Ĩ. Pop arms off ball joints using a forked tool.ħ. Remove three 10mm hex head bolts to remove motor from frame.Ħ. Use a forked tool or screwdriver to pop arm off splined motor shaft.ĥ. Remove arm from motor using 13mm socket and extension through hole above motor shaft nut. ![]() Move wiper motor some and disconnect wiring connector to it and manipulate assembly until you work it out of car.Ĥ. Remove black cover over blower motor relay.ģ. Remove two nuts holding bracket to floor behind false firewall. You have to loosen small round connector, remove connector round nut, slip out of metal bracket. Remove black caps on 10mm hex head bolts near arm pivots, remove bolts/washers, remove metal bracket over right side pivot point, then remove hidden 10mm hex head bolt above motor holding motor frame to ****pit wall.Ģ. Remove black caps on wiper arm 13mm nuts, remove nuts, washers and arms. Removing/repairing AR164 Bosch 3397020238 wiper assemblyġ. ![]()
0 Comments
Leave a Reply. |